Description
The X-Series barrel spacer ring provides additional support for the barrel, and the additional support point acts as a shield so that the silencer and the thread on the weapon are not damaged in the event of an accident. The barrel spacer ring is a standard addition to the X Series and is included with each new model (X108, X149, XE108 and XE149).
Key features:
Additional support point at the barrel
Suitable for X-Series
Made of durable composite
The barrel spacer ring for the X-Series must be adapted to the weapon, see installation instructions below.
The barrel spacer ring is fitted as standard with a hole diameter of approximately 13 mm, which is too small for most barrels and must be adapted. Exceptions are models with M14x1 and M15x1 threads, which are supplied with a hole diameter of 18 mm.
Installation Instructions Support bracket, X Series
The hose spacer ring is mounted directly on the back of the silencer.
Before installing the hose spacer ring, it must be adjusted. The “hole diameter” of the pipe spacer should always be 0.5-0.7 mm larger than the pipe diameter, NOTE that the pipe dimension should be measured where the pipe bracket is positioned when the silencer is installed: X108 /X149 = approx. 130 mm measured from the mouth of the pipe, XE108 / XE149 = approx. 160 mm measured from the mouth of the pipe.
When the spacer ring of the barrel is adapted to the weapon, it is placed at the rear of the silencer. Only attach the pipe spacer ring by hand.
Install the silencer with the pipe spacer ring and check that the adjustment is OK. The pipe spacer ring must never touch the pipe.
IMPORTANT: A hose spacer ring that is touching the hose and/or is stuck will affect hose oscillation and, consequently, hits.
