Description
With thermal adhesive pads from Professor Optiken you have the possibility to optimally adjust or calibrate your thermal imaging device. Handling is very simple – take the thermal pad out of the packaging, peel off the film from the adhesive surface on the back and stick it to a suitable target. Now you can make all the settings on your thermal imaging device, such as adjusting the brightness, contrast or sharpness.
The heating pad reacts with the air immediately after unpacking and heats up to about 40 degrees Celsius in a very short time. This reaction takes about 60 minutes, depending on the ambient temperature. The diameter of the adhesive surface is approx. 60 mm, the thermally active surface is approx. 50 mm. The thermally adhesive pads are packed in a double airtight package. In addition, the outer packaging with a special coating protects the pad against UV and sunlight.
Application:
Remove the heat pad from the packaging and peel the foil from the adhesive surface. Then stick the pad to a suitable target. ATTENTION: The heat pad is activated on contact with air.
Safety instructions:
- use only for the intended purpose
- avoid skin contact
- keep out of the reach of children
- after use, dispose of in accordance with regulations
Ingredients:
Iron powder, vermiculite, activated carbon, water and salt
1 box contains 10 pads
